Vivo V11 1806 ISP PinOUT | Test Point | EDL Mode 9008

In this guide, we will show you the real image of the ISP pinout and test point for the Vivo V11 1806. By using the ISP PinOUT, you can easily restore the stock ROM, bypass FRP lock, or reset user data on your device via UFi Box. In this guide, we will also guide you on how to reboot into 9008 EDL Mode.

What is ISP PinOUT?

ISP or In-system programming also known as in-circuit serial programming (ICSP) for hardware that has a cross-reference of pins or contacts. By shorting the pins together, you can power or signal the logic board (motherboard) of an electronic device such as a mobile, computer. You will find the IS Pinout connection on the logic board of your device. Therefore, you will need to remove the back panel of the handset and follow the below image to locate the pinout.

Vivo V11 ISP Pinout Image:

Vivo V11 1806 ISP PinOUT
Image Credits to tuserhp.com

Vivo V11 Specifications:

The device has a 6.5-inches AMOLED display with 1080×2340 pixels resolution that has a Corning Gorilla Glass 5 protection. It runs on Android 9.0 Pie on top of ColorOS 6.1 UI. It’s powered by the Helio P70 SoC, paired with 8GB RAM, 128GB onboard storage. While the handset supports up to 256GB of MicroSD card. It has a 4,000mAh battery with 20W fast charging support.

The device sports a quad rear camera setup of 48MP (wide) + an 8MP (ultrawide) + a 2MP (B/W) + a 2MP (depth sensor). While the front packs a 16MP motorized pop-up selfie camera. It has Wi-Fi 802.11 a/b/g/n/ac, Bluetooth 4.2, a 3.5mm audio jack, GPS, A-GPS, GLONASS, Type-C port, FM Radio, etc. The handset also has an in-display fingerprint sensor, an accelerometer, gyroscope, proximity, an ambient light, compass sensor.

How to Enter EDL Mode on Vivo V11 (1806)

Follow this instruction carefully to boot your device into EDL Mode (aka Emergency DownLoad Mode)

Method 1: Using ADB

  • Download ADB and Fastboot Tool and extract it in your PC (C:/ Drive)
  • Connect your device to your PC
  • Open the adb command and enter the command
    .\adb reboot edl

Method 2: Using Fastboot

  • Download ADB and Fastboot Tool and extract it in your PC (C:/ Drive)
  • Boot your device into the bootloader
  • Open the command window on your PC on the same folder extracted (ADB and Fastboot Tool)
  • now enter the command
    .\fastboot oem edl

Method 3: By Hardware Test Points / Restore Your device

  • Download the QDLoader driver
  • Find the EDL PinOUT/Test Point on your device (refer image above to find the test point)
  • To enter EDL mode, you need to use a metal tweezer or a conductive metal wire to short the points.
  • Once you are done, connect your device to the PC using a USB cable
  • This way, your device will enter EDL mode. Now you can open the QFil or QPST Tool to flash the firmware and restore your device.

I hope this guide was helpful to find the Vivo V11 1806 ISP Testpoints.

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.